Q2.It is desired to make a product having T-shaped cross-section from a rectangular aluminium
block. Which one of the following processes is expected to provide the highest strength of the
product?
Answer : Option CExplaination / Solution: No Explaination.
Q6.Under optimal conditions of the process the temperatures
experienced by a copper work piece infusion welding, brazing and
soldering are such that
Answer : Option DExplaination / Solution:
Under the optimal conditions temperature of different processes
experienced by a copper work piece is given by
Q7.The part of a gating system which regulates the rate of pouring
of molten metal is
Answer : Option CExplaination / Solution:
Rate of poring molten metal is regulated by choke. As, the choke area
is the minimum area of the gating system, which decide the gating
will be pressurised and unpressurised (or turbulence will occur or
not). Hence, choke is the part which regulate the rate of pouring.
Q8.The non-traditional machining process that essentially
requires vacuum is
Answer : Option AExplaination / Solution:
In electron- beam machining, vacuum conditions are
created/required for material removal, because electrons move
efficiently in vacuum.
Q10.A cube shaped casting solidifies in 5 minutes. The solidification time in minutes for a cube of the same material, which is 8 times heavier than the original casting will be
Answer : Option BExplaination / Solution:
Total Question/Mark :
Scored Mark :
Mark for Correct Answer : 1
Mark for Wrong Answer : -0.5
Mark for Left Answer : 0